Operating Specifications:

1. When using, straighten the rope, and twist it according to 1-2 turns/meter, which can effectively prevent partial wear, and then connect the wire saw into a closed loop with hydraulic pliers and crimps. Before cutting, be sure to distinguish the direction of use of the wire saw, and do not rotate in the opposite direction for cutting.

2. Try to avoid acute angle cutting during use to avoid damage to the rope, and increase the support guide wheel if necessary.

3. The wear of the guide wheel will reduce the fit between the wire saw and the guide wheel, which will affect the wire speed of the wire saw, and thus affect the cutting efficiency. It is necessary to replace the rubber ring of the guide wheel in time.

4. When the wire saw is cutting, it must be cooled, and the amount of water can be adjusted according to the noise during cutting and the turbidity of the cooling water. The amount of cooling water is not as much as possible. Too much cooling water can easily affect the self-sharpening of the wire saw and make the wire saw slip;